Eton VECTOR 250R User Manual download pdf (Page 24)

Page 23

Park the unit on a level surface and lock the

parking brake.

Place the transmission gear selector switch in

the “N”, Neutral, position.

Insert the key into the ignition switch and turn

to the “ON” position.

Turn the engine stop switch to the “ON”

position.

Set the manual choke lever to the full left

position (Choke close or on)

Apply front or rear brakes.

Apply slight pressure to the throttle lever.

Press the starter button on the left-handle bar.

Your unit should start within 10 seconds of

pushing the starter button. If the unit fails to

start check the following.

1. Engine stop switch is “ON”.

2. Parking Brake Locked “ON”.

3. Transmission selector switch in the “N”

position.

4. Set the manual choke lever to the full

left position (Choke close or on)

Driving your ATV

Your ATV should only be driven in an area

that is designated for this use. Insure that the

area is free of obstacles and other dangers

that could cause a loss of control. Check with

your local authorities for any regulations

regarding the use of your ATV.

Always keep your feet on the footrests and

your hands on the handle bar grips while

operating your ATV. Doing so will give you

the best control of the unit.

Start your ATV by following the starting

procedure above and allow the engine a few

minutes to warm up before releasing the

parking brake.

Start the unit by slowly increasing the throttle

until the unit begins moving.

Turning your ATV

Learning to turn your ATV requires you to

learn to shift your weight and control the

throttle to allow the rear wheels to turn properly.

When making a turn, the wheels on the outside

of the turn must travel a wider radius and thus a

greater distance than the inside wheels of the

turn. Since the rear axle does not permit a

different rate of rotation, it is not enough to

merely steer your ATV into the turn.

To turn properly, steer in the direction of the turn

and lean your body to the inside of the turn while

supporting your weight on the outer footrest. Use

the throttle to maintain power throughout the turn.

If you do not use this turning technique the unit

will have a tendency to continue in a straight line.

If this occurs, release the throttle lever to allow

the unit to stop.

Avoid braking or accelerating until you have

regained directional control.

Parking Your ATV

1. Always park your ATV on a level surface.

2. Turn the ignition key to the “OFF’”

position to stop the engine.

3. Set the engine stop switch to “OFF”

position.

4. Engage the parking brake locking button.

5. Turn the fuel valve to the “OFF” position.

6. Remove the ignition key to prevent

unauthorized use or theft of your ATV.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Eton VECTOR 250R User Manual Page 24

Comments to this Manuals