Eton VECTOR 250R User Manual download pdf (Page 20)

Page 19

After riding your unit, be sure to clean any build

up of mud, sand and dirt from the brake rotor skid

plate. This will protect the rotor disc from rust and

corrosion.

To Fill the Reservoir

Remove the reservoir cover by removing the two

cover bolts.

Fill the reservoir to 1/8” from top with Dot-3 SAE-

J1703 grade brake fluid.

Caution: DO NOT allow dirt to fall into the

reservoir.

Refold the cover gasket as shown in picture and

replace cover and bolts

Purging Brake Lines

For the hydraulic brake system to operate safely, the

brake system must be purged of air in the lines and

reservoir.

bleed the air will require two people to perform the

following procedure.

1. Place a drain pan under the brake caliper to

catch the fluid.

2. Open the bleeder valve ½ turn counter

clockwise.

3. Press the brake pedal to expel air from the

system.

4. While holding the brake pedal, close the

bleeder valve.

5. Repeat steps 2 through 4 until the brake fluid

coming from the bleeder valve is a solid

stream without any air, then close the valve

and replace rubber protection cap.

6. Test the brake system by pressing the pedal,

the pedal should feel firm and stop without

fading.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

No comments

Eton VECTOR 250R User Manual Page 20