E-TON Vector 250R OWNER’S MANUAL
Page 9 Engine Stop Switch The stop switch is a red colored rocker switch located on the left-hand handle bar. To start and run the en
Page 10 The throttle cable should be adjusted so there is 2mm, (1/8”) free travel at the lever before the throttle starts to open. Front and Rear Bra
Page 11 Tighten the cap snugly, being careful not to over tighten. Over tightening the cap can cause damage to the cap or seal. The fuel tank capac
Page 12 turning the bowl counter clockwise. Remove the old filter by pulling down on the filter to disengage the pressure fitting from the mount. Ins
Page 13 Changing the engine oil The engine oil requires changing every 1800Mi / 3000KM and at the start of each riding season to protect the engine.
Page 14 Removing the radiator cap while the coolant system is hot can cause over boiling and serious burns or other injuries Engine Coolant Mixture
Page 15 lightly apply pressure to the throttle until you feel the unit shift and the indicator light confirms the shift has been completed. If the b
Page 16 Replace any tire or wheel found to be damaged. Operating your ATV with damaged tires or wheels is dangerous. Damaged tires or wheels can r
Page 17 To maintain the highest performance from your engine and to reduce excessive wear that could cause engine failure the engine requires a conti
Page 18 Brake fluid Dot-3 SAE-J1703 grade. Inspect brake line joints and wheel cylinders for leaks and repair as needed. Apply the brakes by squeezi
Page 1 Important Notices READ and UNDERSTAND this owner’s manual Both the operator and the adult supervisor should completely read and understand t
Page 19 After riding your unit, be sure to clean any build up of mud, sand and dirt from the brake rotor skid plate. This will protect the rotor di
Page 20 Drive Chain The drive chain will stretch with use and will require periodic adjustments. To check the chain tension, remove the chain guard a
Page 21 The cable should be adjusted to allow for ⅛” free travel before the throttle engages the carburetor throttle slide. To adjust the cable’s fre
Page 22 Digital Console The Vector 250 is equipped with a digital console which displays information about the operating conditions of your ATV. In
Page 23 Park the unit on a level surface and lock the parking brake. Place the transmission gear selector switch in the “N”, Neutral, position. Inse
Page 24 Vector 250R Specifications Engine Type Four cycle , Single Cylinder, Liquid cooled Displacement 249cc Bore / Stroke φ71mm * 63mm Compressi
Page 25 Sprockets Front 520x15t Rear 520x38t Chain #520*90 O-Ring Battery Jell Acid (Maintenance Free) 12V-9AH - GTX12-BS Fluids Type Unlead
Page 26 Maintenance Schedule Pre-Ride Safety 300Km200Mi 1000Km600Mi 3000Km1800Mi 6000Km3500Mi 12000Km 7500Mi Vector 250R Inspection 1 Month 3 Months
Page 27 Vector 250R Wire diagram
Page 28 Warranty ETON AMERICA, LLC. LIMITED VEHICLE WARRANTY ETON America warrants all new ETON vehicles sold by authorized Eton Dealers to be free
Page 2 Table of Contents Important Notices...
Page 29 ETON AMERICA, LLC. LIMITED VEHICLE WARRANTY Scheduled maintenance service is the responsibility of the owner during and after the warranty p
Page 30 Owner’s Notes:
Page 3 Table of Contents Maintenance Schedule ...
Page 4 Safety Notes 1. Both the adult supervisor and youth operator must fully understand everything in this manual before operating this vehicle. 2
Page 5 10. NEVER ride this vehicle unless it has been properly maintained and adjusted. Always perform a pre-ride inspection of your vehicle. Look fo
Page 6 13. NEVER REFUEL this vehicle when hot. Ask your adult supervisor to refuel your vehicle. Gasoline is extremely flammable and will ignite if s
Page 7 Additional safety tips: • Participate in an approved ATV safety education training program • Always provide responsible adult supervision f
Page 8 Vehicle Identification Numbers Your VIN RFZ______________ Eng. No._______________ Controls, Switches & Feature Locations Lo
Comments to this Manuals